JRC JMR-611 Instruction Manual page 148

ALARM TYPE
GENERAL WARNING
Table 7-3 shows a list of fuses used in the equipment.
Location
Process Unit
Process Unit
Table 7-2 Alarm message list (GENERAL WARNING)
MASSAGE
MAX Point
No Heading Data
Invalid Data
No Position Data
AIS MAX Target
Not Allowed
POSN Reset
No Card
Card Full
Invalid Card
Read Failed
Write Failed
Erase Failed
Format Failed
Copying
Slave Mode
TXRX Standby
Situation Change
Situation Restore
Battery Low
Battery Dead
Table 7-3 Fuse List
Parts No. Current Rating
F401
F402
Description
Tried to enter navigation information beyond the specified.
N-up selection when bearing data is invalid.
Tried to enter any data beyond its range.
Mark or line input when the latitude and longitude is invalid.
Maximum number of AIS targets.
General operation error.
Change the latitude and longitude sentence.
Card: Not detected yet.
Card: Run out of free space.
Card: Invalid card.
Card: Read failure.
Card: Write failure.
Card: Erase failure.
Card: Unformatted card.
Displayed-image is capturing to file.
Operation of a menu for the scanner unit when the slave
mode is active.
Scanner unit completes pre-heat.
Under changing the Situation Pattern.
Complete setting of the Situation Pattern.
The battery is weakening.
The battery is dead.
Protection Circuit
5A Scanner unit without motor
10A Motor (CBP-202)
7-4
Type
ST4-5AN1
ST6-10AN1