Jøtul FS 73 Installation Instructions Manual page 12

Hide thumbs Also See for FS 73:

Fig. 15

7. NB: The product is heavy! Ask someone to help you place it

inside the surround.

8. Put the burn chamber's levelling screws (A) down on the plate.

We recommend using the two foam rubber grips (B) to protect

your hands. Push the burn chamber backwards until it is in

place. Remove the grips (B), adjust your hold and carefully

lower the front edge of the burn chamber.

9. When the burn chamber is in its place, screw the levelling

screws back again. Refit the insulation sheet.

Fig. 16

10. Refit the inner bottom, air duct and log retainer.

Final assembly

Fig. 17

1. Put the upper fireproof board into position and secure it to

the steel sides using the screws provided.

2. Then finish fitting the top outlet with the flue pipe or steel

chimney (see the installation instructions for the steel

chimney).

3. If desired, the side plate to cover the log store may be

assembled with glue. Included plate can be used on right

or left side.

Fig. 18

4. Position the top section. Make sure it is flush with the side

pieces and fireproof board.

5. Secure firmly on each side using the 4 bolts provided.

ENGLISH

Table of Contents