Jøtul FS 73 Installation Instructions Manual page 11

ENGLISH
Fig. 12
3. Check that everything is level.
Positioning the burnchamber
Read the section on preparing the burn chamber for installation
in the Installation and Operating Instructions for the Jøtul I 520.
NB: Read the instructions regarding pulling up or removing the
inner heat shield (A).
Fig. 13
4. Move the air intake (B) connector beneath the burn chamber
(See Fig. 4 in the manual for Jøtul I 520)
42
A
B
Fig. 14 - a
Fig. 14 - b
5. First remove the log retainer, air duct, inner bottom and then
lift the insulation sheet up. (See Fig. 13, 22, 23, 24 and 25 in the
manual for the Jøtul I 520).
6. Before placing the burn chamber in the surround, unscrew
the two rear levelling screws (A) in the burn chamber to their
maximum length.
A
A