General / Application - Honeywell PL-1000 Installation And User Manual

Fire Alarm Control Panel PL-1000
1

GENERAL / APPLICATION

The purpose of this manual is to provide the user with instructions concerning installation, use and maintenance of the PL-1000 Fire Alarm Control Panel (FACP).
SYSTEM EQUIPMENT
The analogue-addressable PL-1000 FACP is medium in size and very easy to install and configure. The system is designed to manage both traditional wired field
devices and Agile wireless equipment. Installation and commissioning time are reduced to a minimum since the user interface allow in few steps to commission and
tests field devices.
PL-1000 is a single loop addressable panel expandable to two loops with an optional loop card. Each loop supports 159 detectors and 159 input / output modules.
PL-1000 includes Honeywell's Advanced protocol, which maximizes the speed and efficiency of alarm detection, as well as providing maximum information to the
installer.
The 4,3" / 109,2 cm (480 x 272 pixel) Touchscreen provides an intuitive user interface via its touch screen and menus with quick, and easy system operation.
The FACP allows configuration from the screen itself. Due to its size and power, it is the ideal analogue addressable panel for small-medium sites, where maximum
information is required from the installed devices. The panel allows the identification of each of the addressable sensors, with different levels of alarm, to verify the
state of the system, before carrying out any evacuation or transmission to the alarm receiving station or to the building management system.
Do not try to use the control unit and connected devices without reading this manual!
5
M-169.1-SERIE-PL-EN / 09.2022