National Instruments 6583R User Manual And Specifications page 27

Generation (Data, Clock, and PFI Channels)
Minimum
1.125 V
Output impedance ..................................................100 Ω differential, nominal
Output protection ...................................................Each channel can indefinitely sustain a short to any
Note Internal diode clamps may begin conducting outside the 0 V to 3.3 V range.
Acquisition (Data, STROBE, and PFI Channels)
Voltage Threshold
Input impedance.....................................................100 Ω differential, nominal
Input protection......................................................Each channel can indefinitely sustain a short to any
Note Internal diode clamps may begin conducting outside the 0 V to 3.3 V range.
MLVDS Channels (DDC B)
(Consistent with TI part number SN65MLVD207)
Number of programmable I/O voltage levels ........None
Power up state ........................................................Drivers disabled, 100 Ω differential impedance
Fault protection ......................................................Type 2
Typical data rate.....................................................200 Mb/s
Generation (Data, Clock, and PFI Channels)
Minimum
0.8 V
Output impedance ..................................................100 Ω differential, nominal
Output protection ...................................................Each channel can indefinitely sustain a short to any
© National Instruments Corporation
Table 9. Generation Voltage Levels (50 Ω total load)
Offset Voltage
Typical Maximum
1.2 V 1.375 V
Table 10. Acquisition Voltage Levels
Maximum
±50 mV
Table 11. Generation Voltage Levels (50 Ω total load)
Offset Voltage
Maximum
1.2 V
Differential Voltage
Minimum
247 mV
voltage between −0.5 V and 4.0 V.
Voltage Range
Minimum
0 V
voltage between −0.5 V and 4.0 V.
Differential Voltage
Minimum
480 mV
voltage between −1.4 V and 3.8 V.
27
Typical Maximum
340 mV 454 mV
Maximum
2.4 V
Maximum
650 mV
NI 6583R User Guide and Specifications