Bosch D9412GV4 Installation And Operation Manual page 22

D9412GV4/D7412GV4/D7212GV4 | Installation and Operation Guide | 4.0
4.11.5 RF Diagnostics
With a B820 SDI2 Inovonics Interface Module
installed, the control panel can show detailed
wireless communication information for RF
points, keyfobs and repeaters. The RF
Diagnostics menu can show real-time signal
strength information for enrolled RF devices. By
monitoring the signal strength of an individual RF
device, the optimal position for installation can
be found.
RF device diagnostic information also includes AC
status, battery status, supervision status, and
tamper status for all supporting devices. For
details in navigation and operation of these
functions refer to the
D9412GV4/D7412GV4/D7212GV4 Program Entry
Guide (P/N: F01U218312).
4.11.6 IP Diagnostics
With at least one B420 Ethernet Communication
Module installed on the SDI2 bus, the control
panels can use the diagnostic functions of this
menu to retrieve the auto-configured settings
from the module and perform a series of network
communication tests. This menu does not apply
to the DX4020 modules on the SDI bus.
The Settings option retrieves the following from
the selected B420 module: Unit Host Name, MAC
ID, and current IPV4 Address.
The Connection Test option performs the
following automated tests for the selected B420
module:
Link [OK] if Ethernet cable is detected
[Missing] if Ethernet cable is not
detected.
Gateway [OK] if an ICMP echo request (PING)
response is received from the Gateway
Address. [Failure] if response is not
received.
Internet [OK] if an ICMP echo request (PING)
response is received from the IP Test
Address. [Failure] if response is not
received.
Refer to the D9412GV4/D7412GV4/D721GV4
Program Entry Guide (P/N: F01U218312) for
details on the B420 Ethernet Communication
Module configuration.
Bosch Security Systems, Inc. | 3/12 | F01U266054-01
Installation
22