Advertisement
6. Installation
6.1 EZN models
1. Drill three holes on the surface according to the screw positions on the
Camera Base. Push the supplied 3 Screw Anchors into the holes. Drill another
hole in the middle within the 3 screw holes if you wish to run the wires into
the surface. Screw the camera to surface using the supplied 3 Screws.
2. Adjust the pan/tilt/rotate angles of the camera by loosen the Pan/Tilt screws
using the supplied Hexagon Wrench.
3. Connect the camera to power. You can either connect the camera to a 12VDC
power source or to a PoE switch using the PoE cable.
4. Connect the camera to the network using the supplied Cable Gland Kit. See 5.
Cables.
5. Insert a Micro SD card into the card slot (optional).
6. Now you can access the camera live view. See 7. Accessing the Camera.
Screw Anchors
Mounting Screws
Tilt Screw
Pan Screw
11
Advertisement
