Table of Contents
Advertisement
Estimated time of arrival at destination / remaining driving time to desti-
nation
Remaining distance to the destination
Chosen route type (economic, fastest, shortest)
C
Current vehicle position (address / GPS coordinates)
D
The display of the arrival time or the remaining driving time can be adjusted as
follows.
▶
In the Navigation main menu, tap on the function interface → Advanced set-
tings → Time display:) .
Several route destinations
In the route plan, the following information is displayed at the respective desti-
nations» fig. 231
- .
Area with function interfaces
A
Stopover (with sequential number)
Final destination
Estimated time of arrival at destination / stopover
Driving distance to destination / stopover
Substitution of destinations among themselves
Delete the destination
Continuation of the route guidance from the selected destination (previ-
ous waypoints are skipped)
Display the destination details
Insert destination into the route
In the area
, tap on the function surface Enter destination and enter a new
▶
A
destination.
▶
or: Tap on the area
the function surface destinations and select an object in
A
the list of stored destinations.
Each additional destination is added to the list as the first subsequent destina-
tion route.
Change positions of destinations with each other
▶
The relevant function interface and move the destination to the desired
position.
With destinations on the route already reached the note Dest. reached is dis-
played below the destination name. It is not possible to change the position of
these destinations with each other.
» page 184
Store route
In the area
, tap the function interface Save.
▶
A
▶
Save the edited route as a new route or replace the existing saved route.
The route is saved in the route list
Stop route guidance
▶
In the area
, tap the function interface stop .
A
Route change in the map
Only valid for Infotainment Columbus.
Fig. 232 Route change in the map / route transit point
A route in which there are no stopovers can be changed during route guidance
by inserting a transit point.
Add a transit point
›
In the Navigation main menu, tap on the function interface → Change route in
map.
›
Touch the screen in the route field and move the cross-point to the desired
location on the map, e.g.
, move
A
The transit point
is added to the route
B
›
The function surface .
Then a new route is calculated and route guidance starts.
Customize transit point
›
In the Navigation main menu, tap on the function interface → Change route in
map.
›
Touch the transit point
and move to a different location on the map.
B
›
Tap on the function interface .
» page
188.
» fig.
232).
» fig.
232.
Navigation
187
Advertisement
Table of Contents
