Installing The Evs-100W; 1: Evs-100W Board Layout - Honeywell SILENT KNIGHT EVS Series Manual

EVS Device Installation
Batteries larger than 18 AH will not fit in the main control cabinet, and must be housed in the RBB Accessory Battery Cabinet. The system
supports a maximum of 35 AH batteries.
EVS-125W
EVS-CE4
A Current Subtotals:
Notification Devices
B Current Subtotals:
C Total current rating of all devices in system (Line B) X 0.001
D Number of standby hours (24 or 60 for NFPA 72)
E Multiply line C (standby current) and D:
F Alarm sounding period in hours (For example, 5 minutes = 0.0833 hours):
G Multiply line C (alarm current) and F:
H Add lines E and G (AH = Ampere Hours):

4.6 Installing the EVS-100W

This section provides information on how to install the EVS-100 for use with the 5820XL-EVS or 6820EVS.
4.6.1 EVS-100W Board Layout
Figure 4.34 shows the location of terminals, DIP switches and expander connection used in the installation of the EVS-100W.
34
Device
Table 4.4 Current Draw EVS-125W
AC connector
battery
connector
Figure 4.34 Components Layout for EVS-100W
No. of
Current Per Device
Devices
1 Standby:
Alarm:
0 or 1 Standby:
Alarm (All Channels):
Refer to device manual for number of devices and current ratings.
backup card connector
audio circuits
EVS Series Manual — P/N LS10062-001SK-E:D 3/15/2022
Installing the EVS-100W
Standby
Current
375 mA 375mA
700 mA
20 mA 20mA
180 mA
Total standby AH
Total alarm AH
Total AH required
VBUS1 VBUS2
SBUS ID
DIP switch
amp mode
DIP switch
SBUS
Alarm
Current
700mA
180mA
mA mA
mA mA
A A
H
AH
H
AH
AH
test switches