Getting Started - Oregon Scientific 18026 Instruction Manual

X18-Manual (US) 7/16/02 5:09 PM
Chapter 2
Chapter 2

Getting Started

The Accelerator X18 operates on 4 AA size batteries (not included) or a 9V AC adaptor
(sold separately).
Battery Installation
1. Make sure the unit is turned off.
2. Using a Phillips-head screwdriver, open the battery cover atthe back of the unit.
3. Insert 4"AA" batteries. (Note the correct polarity: +, - ).
4. Replace the cover.
AC Adaptor Connection
Plug the adaptor into the adaptor jack (center posi-
tive type) on the left side of the unit. Plug the
adaptor into a wall outlet.
Please turn off the unit before plugging in the AC
adaptor. Otherwise the unit may be damaged.
Page 7
Caution
• Do not mix different types of batteries or old and new batteries.
• Only use batteries of the same or equivalent type as recommended.
• Remove all batteries when replacing.
• Remove batteries from the unit if the unit is not going to be used
for long periods of time.
• Do not dispose of batteries in fire.
• Do not recharge non-rechargeable batteries.
• Rechargeable batteries are to be removed from the toy before
being charged.
• Rechargeable batteries are only to be charged under adult
supervision.
• Remove exhausted batteries from the toy.
• Do not short-circuit the supply terminals.
Caution
• The unit must not be connected to a power supply greater than 9V.
• Only use the recommended adaptor.
• The adaptor is not a toy.
• Do not short-circuit the supply terminals.
• Toys liable to be cleaned with liquid are to be disconnected
from the transformer before cleaning.
+
-
3