Compaq Deskpro 2000 Maintenance & Service Manual page 256

Table G-11
Continued
Problem Cause
1. Network drivers are not
Network controller stopped
working when an expansion
board was added to the
computer.
2. The cable is not securely
3. The network controller
4. The network controller
5. The files containing the
1. The files containing the
Network controller stopped
working without apparent
cause.
2. The cable is not securely
3. The network controller
Solution
1. Make sure that the network drivers are loaded and that the driver
loaded or driver parameters
do not match the current
configuration.
2. Ensure that the cable is securely attached to the network
connected.
3. Run Computer Setup and modify the network controller memory
interrupt or memory overlaps
4. Verify that the drivers were not accidentally deleted when the
the interrupt or memory of
another expansion board.
5. Reinstall the network drivers, using the backup diskettes and
require drivers.
network drivers are
corrupted.
1. Reinstall the network drivers using the backup diskettes and
network drivers are
corrupted.
2. Ensure that the cable is securely attached to the network
connected.
3. Replace the network controller or system board.
is defective.
parameters match the configuration of the network controller
using Network Setup found in the Control Center.
connector and that the other end of the cable is securely
attached to the correct device.
value.
drivers for a new expansion board were installed.
then run Computer Setup.
then run Computer Setup.
connector and that the other end of the cable is securely
attached to the correct device.
Compaq Deskpro 2000 Series of Personal Computers G-11