Compaq Deskpro 2000 Maintenance & Service Manual page 179

4. Remove the two screws on the left side of the drive bay that secure the drive to the chassis.
5. Pull the drive straight out of the chassis.
Figure 6-37. Removing the CD-ROM Drive
When replacing this drive, transfer the wafer screw that takes the place of a drive rail from the old
drive to the new one. The screw is located on the right side of the drive, in the middle.
To replace the 5.25-inch drive, reverse the above procedures.
Compaq Deskpro 2000 Series of Personal Computers 6-37