Configuration Option Settings - 3Com EtherLink III User Manual

4-6 C
HAPTER
Configuration Option Settings
Table 4-1 lists each software option, the default setting,
and the available settings. For more information about
each setting, select the option and press [F1]).
.
Table 4-1 Option Settings
Option
I/O Base Address
Interrupt
Request Level
Boot PROM
Transceiver Type
Network Driver
Optimization
Maximum
Modem Speed
(fastest modem
installed)
Plug and Play
Full Duplex
If you are using a PC that supports Plug and Play, the IRQ
and I/O base address values are set by Plug and Play. You
can set the boot PROM size to indicate the presence and
size of a network boot PROM.
To disable Plug and Play at the DOS command line, type:
3C5X9cfg configure /pnp:n [Enter]
You can also type:
pnpdsabl.bat [Enter]
4: C
ONFIGURING THE
Default Setting
300h
10
Disabled. Does not
apply for
3C509B-TPO
Auto Select for all
except
3C509B-TPO
(on-board TP)
Windows or OS/2
Client
9600 Baud
Enabled
Disabled
3C509B NIC
Available Settings
200h, 210h, 220h, 230h, 240h, 250h,
260h, 270h, 280h, 290h, 2A0h, 2B0h,
2C0h, 2D0h, 2E0h, 2F0h, 300h, 310h,
320h, 330h, 340h, 350h, 360h, 370h,
380h, 390h, 3A0h, 3B0h, 3C0h,
3D0h, 3E0h, EISA, ISA
3, 5, 7, 9, 10, 11, 12, 15
Disabled, 8 K, 16 K, 32 K
On-board Coax (BNC), On-board TP
(RJ-45), External (AUI/DIX), or Auto
Select
DOS Client, Windows or OS/2 Client,
Server
No Modem, 1200, 2400, 9600, 19200,
or 38400 Baud
Enabled, Disabled
Enabled, Disabled