3Com EtherLink III User Manual page 24

3-2 C 3: I
HAPTER
Follow these steps to install the NDIS 3.x network driver
in a PC running Windows 95.
1 Install and configure Windows 95 before installing
the 3C509B NIC.
2 Delete the \WINDOWS\INF\NET3COM.INF and
\WINDOWS\INF\W95EL5X9.INF files if they
are present.
3 Install the 3C509B NIC and connect it to the network
as described in Chapter 2.
4 Restart the PC.
Windows 95 autodetects the NIC in the PC.
If Windows 95 does not detect the 3C509B NIC, open
the Control Panel and click Add New Hardware. This
causes the NIC to be detected.
5 Select Driver from disk provided by the hardware
manufacturer and click OK.
6 Insert the 3Com EtherDisk diskette in your floppy
drive, and if the diskette is in drive A, click OK.
Supply the correct drive letter, if required.
Once the installation files are read, Windows 95 prompts
you for the Windows 95 network installation files.
7 Enter the correct pointer to the Windows 95 files
(hard drive, CD-ROM, or diskette) and click OK.
Once the driver is installed, check to make sure that the
proper network components were loaded. If Windows
prompts you to reboot or shut down, click No.
8 Open the Windows 95 Control Panel.
9 In the Control Panel, double-click Network.
10 For Microsoft networks, select the Configuration
tab. For Novell NetWare networks, go to step 11.
The default Microsoft network setup contains the
following five components:
Client for Microsoft Networks
Client for Novell Networks
3Com EtherLink III driver
IPX/SPX compatible protocol
NetBEUI protocol
N
NSTALLING THE ETWORK
D
RIVERS