Mitsubishi MELSEC AJ65BT-R2 User Manual page 193

8 OTHER FUNCTIONS
Registration execution
(4) Program
The following shows the program for registration to the E2PROM of the R2.
The following program assumes that the buffer memory automatic update
function is used.
Refer to Section 5.1 for program conditions.
(a) When using the FROM/TO command with the ACPU / QCPU-
A (A mode)
1) Program to change to bank 0
2) Program to change to bank 2
8 - 21
MELSEC-A
Pulsate registration
execution signal
Change to bank 2
Write "0" in to
R2 1C0
H
register (default value is "4")
Change to bank 0
Set EEPROM function
request (RYn7)
Reset EEPROM function
request (RYn7)
Specify partial refresh
Specify bank 0
Execute partial refresh
Specify partial refresh
Specify bank 2
Execute partial refresh