Mitsubishi MELSEC AJ65BT-R2 User Manual page 103

5 PRELIMINARY INFORMATION
Write execution
1) Program to change to bank 0
2) Program to change to bank 1
(b) When using dedicated commands (RIWT) with QCPU (Q
mode) / QnACPU
When using dedicated commands (RIWT/RISEND), RY(n+1)E and
RY(n+1)F are used with the dedicated commands, so provisions must be
made to prevent the user from rewriting this signal information.
When the QCPU (Q mode) is used, such provisions need not be made.
Refer to section 5.3(8) for details.
5 - 45
MELSEC-A
Specify partial
refresh
Specify bank 0
Execute partial
refresh
Specify partial
refresh
Specify bank 1
Execute partial
refresh
Set R2 station No.
Access code, attribute
R2 buffer memory address
No. of write points
Write data
Write execution