Rear Panel - Onkyo T-4555 Instruction Manual

Getting to Know the T-4555—Continued

Rear Panel

1 2
For detailed information, refer to the pages in parentheses.
A
SIRIUS ANTENNA (22)
This jack is for connecting the SiriusConnect
receiver (not supplied).
B
XM ANTENNA (18)
This jack is for connecting the XM Mini-Tuner (not
supplied).
C
FM 75Ω ANTENNA (11)
This jack is for connecting the supplied indoor FM
antenna or an outdoor FM antenna.
D
AM ANTENNA (11)
These terminals are for connecting the supplied AM
loop antenna or an outdoor AM antenna.
E
AUDIO OUTPUT (13)
Using the supplied audio cable, connect these out-
put jacks to an analog audio input on your amp.
F
REMOTE CONTROL (13)
These two identical
can be connected to the
Onkyo components for interactive control. To use
, the T-4555 must be connected with an
cable and an audio cable.
G
12V TRIGGER IN/OUT (14)
The 12V TRIGGER IN jack can be connected to the
12-volt trigger output on another component, so that
when the other component is turned on, the T-4555
turns on as well.
The 12V TRIGGER OUT jack can be connected to
the 12-volt trigger input on another component, so
that when the T-4555 is turned on, the other compo-
nent turns on as well.
8
3 4
(Remote Interactive) jacks
jacks on your other
5 6 7 8
H
IR IN/OUT (15)
A commercially available IR receiver can be con-
nected to the IR IN jack, allowing you to control the
T-4555 while you're in another room, or control it
when it's out of sight, for example, installed in a
cabinet.
A commercially available IR emitter can be con-
nected to the IR OUT jack to pass IR (infrared)
remote control signals through to other components.
I
RS232
This port is for connecting the T-4555 to home
automation equipment and external controllers.
J
Power cord (4)
The power cord should be connected to a suitable
wall outlet.
See pages 13–15 for connection information.
9
J