Remote Controller Setup; Lock Setup; Using The Audio Settings - Onkyo TX-NR809 Instruction Manual

Remote Controller Setup

Main menu Remote Controller Setup
Remote Mode Setup
See "Looking up for Remote Control Code"
(➔ page 73).
Activities Setup
Via onscreen menu, you can specify what actions will be
taken by the Easy macro command in the Easy macro
mode (➔ page 43).
First, select the ACTIVITIES (MY MOVIE, MY TV, or
MY MUSIC) that you want to configure.
■
Source
BD/DVD, VCR/DVR, CBL/SAT, GAME, PC,
AUX, TUNER, TV/CD, PHONO, PORT, NET,
USB
With this setting, you can choose the target input source
of the Easy macro.
■
TV Power On
Enable
Disable
With this setting, you can specify whether or not to turn
on your TV.
■
Source Power On
Enable
Disable
With this setting, you can specify whether or not to turn
on the source component.
■
Receiver Power On
Enable
Disable
With this setting, you can specify whether or not to turn
on the AV receiver.
■
Receiver Source Change
Enable
Disable
With this setting, you can specify whether or not to
change the input source.
■
Source Play
Enable
Disable
With this setting, you can specify whether or not to start
playback.

Lock Setup

With this preference, you can protect your settings by
locking the setup menus.
Main menu Lock Setup
■
Setup
Locked
Unlocked
When "Locked" is selected, the setup menus will be
locked and you cannot change any setting.

Using the Audio Settings

You can change various audio settings from the Home
menu (➔ page 40).
1 Press RECEIVER followed by HOME.
2
Use q/w and ENTER to select "Audio", and then
use q/w/e/r to make the desired selection.
Note
• These settings are not available in either of the following cases:
– a pair of headphones is connected.
– the "Audio TV Out" setting is set to "On"
– "HDMI Control(RIHD)" is set to "On"
you're listening through your TV speakers.
Tone Control Settings
■
Bass
–10dB to 0dB to +10dB in 2 dB steps.
You can boost or cut low-frequency sounds output
from the front speakers.
■
Treble
–10dB to 0dB to +10dB in 2 dB steps.
You can boost or cut high-frequency sounds output
from the front speakers.
You can adjust the bass and treble for the front speakers,
except when the Direct, Pure Audio or THX listening
mode is selected.
Operating on the AV receiver
1 Press TONE repeatedly to select either "Bass" or
"Treble".
2 Use + and – to adjust.
Note
• This setting is not available when the multichannel Analog input
is selected.
(➔ page 61).
(➔ page 60) and
En
63