Toshiba STOR.E TV+ User Manual page 48

STOR.E TV+
6. If you want to access files that are stored on a USB data storage device
which is connected to a router and thus made available as network
storage, please note that you must set up a connection to the drive
using "My_Shortcuts". To do so, you must enter the IP address of your
router as well as the user name and the password necessary to access
the network storage.
Hardware issues
Question 1:
While using STOR.E TV+, it no longer responds to my commands.
Answer:
This problem may have several causes. Please check the following items:
1. Aim the remote control in the direction of STOR.E TV+ so that direct
visual contact between these two devices exists and ensure that the
infrared receiver of the remote control and STOR.E TV+ are not
covered.
2. Check the battery in the remote control and, if necessary, replace it with
a new one.
Question 2:
I want to copy files onto an external data storage device with my Player, but
I always get an error message.
Answer:
To use the copy function of your Player, the device (or the partition), that
you want to copy the data onto, must be formatted with one of the following
file systems: FAT, FAT32, NTFS, ext3. Use only targets formatted with FAT,
FAT32, NTFS or ext3 to receive the copied files.
Audio issues
Question 1:
There is no sound coming from my television when I connect the
STOR.E TV+ via HDMI.
Answer:
This problem may have several causes. Please check the following items:
1. An audio output format is selected that is not supported by your
television.
2. The volume is to low/Mute is active.
3. Select the correct digital output mode in the Setup Menu. Go to the
audio settings menu and select "Digital-Audio-Out" and choose the
option "HDMI LPCM/RAW" if your television set does not support real
surround sound. Also refer to the Audio Settings.
EN-48 User's Manual