Wind Hold Adjustment; Tack And Gybe; Tack And Gybe Settings - Garmin GHP 10V Marine Autopilot System Owner's Manual

Sailboat Autopilot Operation

Wind Hold adjustment

You can adjust the wind hold angle using the soft keys on the autopilot when
wind hold is engaged.
adjusting the Wind Hold angle with the autopilot
You can adjust the wind hold angle using step steering on the autopilot.
Select or
of 1°.
Hold or to adjust the wind hold angle in larger
increments. The increment size is shown on the soft key and is the same
as the step steering increment
The heading dial on the wind screen shows your actual heading
intended heading while the autopilot steers the boat.
➋
14
to adjust the wind hold angle in increments
(page 12).
➊
➊
➋

Tack and gybe

You can set the autopilot to perform a tack or gybe while heading hold or
wind hold is engaged.

Tack and gybe settings

Settings that define how the autopilot performs a tack or gybe are set up
during the installation. However, if the autopilot is not performing a tack or
gybe in a safe or satisfactory manner, you may want to adjust the following
settings:
• Heading Hold Tack Angle
• Tack/Gybe Delay
and
• Gybe Inhibitor
• Wind Hold Type
• Wind Limiter
Tacking and gybing from Heading Hold
Before you begin a tack or gybe from heading hold, you must set the heading
hold tack angle (page
1. Engage heading hold
2. Select Menu > Tack/Gybe.
3. Select
The autopilot steers your boat through a tack or gybe, and the heading
screen shows a "Tacking" message until the maneuver is complete.
(page 17)
(page 17)
(page 17)
(page 18)
(page 18)
17).
(page 3).
or to choose a direction.
GHC 10 Owner's Manual