Advertisement
Conduit Opening
The torque required to tighten a connector other than a
1/2-14NPT connector is 1.77 to 2.16 N S m. The torque required
to tighten a 1/2-14NPT connector is 1.37 to 1.77 N S m.
The casing may be damaged if an excessive tightening torque is
applied. For the casing to maintain IP65, apply sealing tape
between the connector and conduit opening. Be sure that the
diameter of the cable connected to the connector is correct.
When wiring a 2-conduit model, attach and tighten a conduit cap
to the unused conduit opening. The torque to be applied to the
conduit cap is 1.27 to 1.67 N S m. The conduit cap is provided
with the D4DH.
Recommended Connectors
Size
Manufacturer
1
G
/
/
OMRON
2
2
LAPP
Ohm Denki
Pg13.5
LAPP
1
/
-14NPT
LAPP
2
Note: LAPP is a German manufacturer.
Ohm Denki is a Japanese manufacturer.
Maintenance and Repairs
Please note in the machine manufacturer's instruction manual
that the user must not repair or maintain the Switch and must
contact the machine manufacturer for any repairs or
maintenance.
Using the D4DH
Use the D4BS under conditions requiring greater rigidity, sealing
performance, and oil resistance.
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters into inches, divide by 25.4
OMRON ELECTRONICS LLC
One Commerce Drive
Schaumburg, IL 60173
847-843-7900
For US technical support or other inquiries:
800-556-6766
Cat. No. GC SAFETY-2
Model
Cable diameter
SC-6
7.5 to 9.0 mm
ST-PF1/2
6.0 to 12.0 mm
5380-1002
OA-W1609
7.0 to 9.0 mm
ST13.5
5.0 to 12.0 mm
5301-5030
ST-NPT1/2
6.0 to 12.0 mm
5301-6030
OMRON CANADA, INC.
885 Milner Avenue
Toronto, Ontario M1B 5V8
416-286-6465
2/03
Specifications subject to change without notice
OMRON ON-LINE
Global - http://www.omron.com
USA - http://www.omron.com/oei
Canada - http://www.omron.ca
11
D4DH
Printed in USA
Advertisement
