Siemens SIMATIC ET 200SP Manual page 48

Compatibility
6.1 Compatibility of modules
Status of the supply voltage
Load voltage diagnostics are only valid if the station started up with a valid and complete
configuration.
● For modules without parameter assignment in the following table, the status of the supply
voltage (status byte of the server module) is always signaled as "1" regardless of the
actual status of the supply voltage.
● If a potential group is exclusively made up of modules without parameter assignment from
the table below, no group diagnostics "Missing supply voltage L+" is signaled for this
potential group.
Module
DI 8x24VDC ST
DI 16x24VDC ST
DI 8x24VDC HF
DQ 4x24VDC/2A ST
DQ 8x24VDC/0.5A ST
DQ 16x24VDC/0.5A ST
DQ 8x24VDC/0.5A HF
Resetting an interface module to factory settings via the RESET button
There is a special operation for interface module IM 155-6 PN HF V2.0 to reset it to the
factory settings using the Reset button.
Requirements
The supply voltage to the interface module must be switched on.
Required tools
3 to 3.5 mm screwdriver (for resetting with a RESET button)
Procedure
1. Remove the interface module from the mounting rail and swivel it downwards.
2. The RESET button is located on the back of the interface module behind a small opening:
Push a screwdriver into the small opening, thus pressing the RESET button.
3. Release the RESET button.
4. Press the RESET button for another 3 seconds.
5. Look at the LED display of the interface module to see whether the reset was successful:
RUN LED flashes for 3 seconds, ERROR and MAINT LED are off.
6. Install the interface module back on the mounting rail.
7. Assign parameters to the interface module again.
48
Article number
6ES7132-6BF00-0BA0
6ES7131-6BH00-0BA0
6ES7132-6BF00-0CA0
6ES7132-6BD20-0BA0
6ES7132-6BF00-0BA0
6ES7132-6BH00-0BA0
6ES7131-6BF00-0CA0
IM 155-6 PN HF interface module (6ES7155-6AU00-0CN0)
Manual, 03/2015, A5E03915895-AF