Parameter Mode - Mitsubishi Electric MELSERVO-J4 MR-J4 A Series Instruction Manual

4. STARTUP

4.5.6 Parameter mode

(1) Parameter mode transition
After selecting the corresponding parameter mode with the "MODE" button, pushing the "UP" or
"DOWN" button changes the display as shown below.
To status display mode
Basic setting
Alarm mode
parameters
[Pr.PA01]
[Pr.PA02]
[Pr.PA31]
[Pr.PA32]
POINT
To use the I/O setting parameters, change [Pr. PA19 Parameter writing inhibit].
(Refer to section 5.1.1)
Gain/filter Extension setting
parameters
parameters
[Pr.PB01] [Pr.PC01]
[Pr.PB02] [Pr.PC02]
[Pr.PB63] [Pr.PC79]
[Pr.PB64] [Pr.PC80]
MODE
I/O setting
parameters
[Pr.PD01]
[Pr.PD02]
[Pr.PD47]
[Pr.PD48]
4 - 28
Extension setting 3
Extension setting 2 2
parameters
parameters
[Pr.PE01] [Pr.PF01]
[Pr.PE02] [Pr.PF02]
[Pr.PE63] [Pr.PF47]
[Pr.PE64] [Pr.PF48]
3
UP
DOWN