Table of Contents
Advertisement
Auto restart function setting
This product is designed so that, after a power
failure, it can restart automatically in the same
operating mode as before the power failure.
Information
The product was shipped with Auto Restart function
in the OFF position.
Turn it ON as required.
How to turn ON the Auto Restart Function
• Press and hold the [OPERATION] button on the
indoor unit for 3 seconds
(3 beep sounds but OPERATION lamp does not
blink).
How to turn OFF the Auto Restart Function
• Press and hold the [OPERATION] button on the
indoor unit for 3 seconds
(3 beep sounds and OPERATION lamp blink
5 time/sec for 5 seconds).
NOTE
• In case of ON timer or OFF timer are set,
AUTO RESTART OPERATION does not activate.
Self cleaning operation
(cool and dry operation only)
To protect bad smell caused by the humidity in the
indoor unit.
1. If the
button is pressed once during
"Cool" or "Dry" mode, the fan will continue to
run for other 30 minutes, then it will turn off
automatically. This will reduce the moisture in
the indoor unit.
2. To stop the unit immediately, press the
more 2 times within 30 seconds.
Remote control A-B selection
To separate using of remote control for each indoor
unit in case of 2 air conditioners are installed
nearly.
Remote Control B Setup.
1. Press RESET button on the indoor unit to turn
the air conditioner ON.
2. Point the remote control at the indoor unit.
3. Push and hold
Remote Control "00" will be shown on the
display. (Picture 1)
4. Press
during pushing . "B" will show on
the display and "00" will disappear and the air
conditioner will turn OFF. The Remote Control B
is memorized. (Picture 2)
NOTE
1. Repeat above step to reset Remote Control to
be A.
2. Remote Control A has not "A" display.
3. Default setting of Remote Control from factory
is A.
1
- 19 -
Owner's Manual
button on the back side of
2
19-EN
Advertisement
Table of Contents
