Replacing The Lamp And Air Filter - Epson PowerLite 1716 User Manual

note
When you get a replacement
lamp for your projector, you
should replace the filter.
To check how long the lamp
has been in use, see
page 127.
Turn off this product when
not in use to prolong the life
of the projector.
warning
Let the lamp cool fully
before replacing it.
In the unlikely event that
the lamp has broken, small
glass fragments may be
present and should be
removed carefully to avoid
injury.
If the lamp is used after the
replacement period has
passed, the possibility that
the lamp may break
increases. When a lamp
replacement message
appears, replace the lamp
with a new one as soon as
possible, even if it is still
working.
Maintaining the Projector
118

Replacing the Lamp and Air Filter

The life span of the projection lamp is up to 3000 hours if
in the Setting menu is set to
Brightness Control
4000 hours if
Brightness Control
It is time to replace the lamp when:
The projected image gets darker or starts to deteriorate.
■
The message
■ Replace the lamp
lamp comes on and the lamp warning light
maintain projector brightness and image quality, replace the lamp
as soon as possible.
■ The lamp warning light
Contact your dealer or call Epson at 800-GO-EPSON
(800-463-7766). Request part number V13H010L48.
Follow these steps to replace the lamp and air filter:
1. Turn off the projector.
2. When the P power light stops flashing, unplug the power cord.
3. Let the projector cool for at least an hour (if it has been on). The
lamp is extremely hot immediately after use.
High
is set to .
Low
appears on the screen when the
flashes orange. To
flashes red (the lamp is burnt out).
(default), and