Solving Problems
134
of the screen). On a Mac, you may be able to adjust the volume
from your menu bar (top right corner of the screen) or via the
volume control function keys.
■
If you are using the projector's internal speaker, make sure the
EasyMP Audio Out
■
If you are using external speakers, you need to set the
option to
Audio Out
information.
Solving Network Problems
You can't display an image using Quick Wireless
Connection.
You may need to restart your computer to connect.
You can't connect to the projector using NS Connection.
Make sure the optional wireless module is installed correctly in
■
the projector, as shown on the Quick Setup sheet.
Restart your computer.
■
Make sure your projector and computer are configured correctly;
■
see page 58 (Ad Hoc mode) or page 64 (Access Point mode).
Make sure that you have sufficient wireless signal strength (above
■
50 percent). On a Mac, check the AirPort icon on the Mac menu
bar. In Windows, see the documentation for your computer's
wireless card or adapter for details.
Make sure you aren't projecting one of the EasyMP configuration
■
screens. (You should see a message that the projector is ready to
connect.) If you have to exit a configuration screen, restart
NS Connection.
■
If the projector is configured for Access Point mode and you're
using DHCP, allow time for your projector to appear. It takes the
server a little while to pick up the IP address.
option is set to
Internal
. See page 51 or page 105 for more
External
.
EasyMP