Epson PowerLite 1716 User Manual page 92

note
If a critical problem develops
with a projector which
causes it to suddenly stop
working, it may not be
possible for the projector to
send a message.
If Standby Mode is set to
Network ON in the
Extended menu, the
projector can still be
monitored even if the
projector is in standby mode
(when the power is off).
Setting Up Network Projection
92
3. Choose , then press
Mail
4. Highlight to receive email notifications, then press
On
5. Enter the IP address for the SMTP server for the projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used: 127.x.x.x,
224.0.0.0 to 255.255.255.255 (where x is a number from 0 to
255).
6. Enter the SMTP server's port number. The default value is 25.
You can enter a numeric value from 1 to 65535.
7. Choose one of the
e-mail address and the contents of the message that you will
receive when a problem or warning occurs. You can register up to
three addresses. You can enter up to 32 alphanumeric characters
for the e-mail address.
8. Select problems or warnings to be notified about by mail.
. You see the following screen:
Enter
Destination Address
.
Enter
fields, then enter the