Removing the Wireless Module
If you need to remove the wireless module (802.11a/b/g) from your
projector, follow these steps:
1. If you're running NS Connection, click
control bar.
2. Check the access light to make sure it isn't flashing.
3. Turn off the projector and unplug it.
4. Turn the projector over. Unscrew the cover plate, then remove it.
5. Slide the module out of the projector.
6. Replace the cover plate and secure it with the screw.
on the
Disconnect
Click
Disconnect
Setting Up Network Projection
caution
Never remove the module
while the indicator light is
green or when projecting
wirelessly. You may damage
the module or lose data.
89