Table of Contents
Advertisement
Steps
1. Align the notch on the memory module with the tab on the memory-module slot on the system board.
2. Slide the memory module firmly into the memory-module slot at an angle.
3. Press down on the memory module to snap it into place on the system board. Ensure that the memory-module retention
clips have locked the memory module into place.
NOTE:
If you do not hear the click, remove the memory module and reinstall it.
4. Repeat steps 1, 2 and 3 to install the second memory module, if applicable.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
M.2 solid-state drive
Removing the M.2 2230 solid-state drive
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs)
45
Advertisement
Table of Contents
