Table of Contents
Advertisement
6. Gently flip the display panel assembly forward, peel back the tape that secures the display cable to the connector on the rear
of the display panel.
NOTE:
Ensure that the panel has a clean and smooth surface to rest on, to prevent damage.
7. Disconnect the display cable from the connector on the display panel and remove the display panel.
NOTE:
The display panel is assembled with the display brackets as a single service part. DO NOT pull the two pieces of
elastic tape and separate the brackets from the panel.
Installing the display panel
CAUTION:
The information in this section is intended for authorized service technicians only.
108
Removing and installing Field Replaceable Units (FRUs)
Advertisement
Table of Contents
