Changing Temperature Scale - Hearth and Home Technologies IntelliFire Plus RC300-MON-VFL Installation & Operating Instructions Manual

Changing Temperature Scale

To change the temperature display between Celsius and
Fahrenheit, remove the battery cover from the back of the
remote control and slide the switch to your desired tem-
perature scale (see Figure 1). The screen will automati-
cally change the indicators on the room temperature and
set temperature portion.
Figure 1. Temperature scale
Installation of Remote Control Housing
CAUTION! Risk of Fire! DO NOT install damaged or
modified components Warranty will be voided if damaged
.
or modified components are installed.
Kit components: One remote control, two #6 screws, two
wall anchors, 3 AAA batteries. If batteries are properly in-
stalled the remote will turn on
1. Remove remote control components from packaging.
2. Remove battery cover from the back of the remote by
sliding it down and install 3 AAA batteries.
To prevent unintended operation when not using your ap-
pliance for an extended period of time (summer months,
vacation, trips, etc):
• Remove batteries from remote control.
• Unplug switching adapter and remove back-up batteries.
3. Secure the remote control housing on a flat wall sur-
face using the two screws and wall anchors provided.
See Figure 2.
Figure 2. Mounting Remote Control Housing
2 Hearth & Home Technologies • RC300-MON-VFL Multifunction Remote Control • 4018-900 Rev. B • 02/21
4. Place remote control inside housing. See Figure 3.
Figure 3. Remote in Housing
5. Close the housing door. See Figure 4.
Figure 4. Mounting Remote Control Housing