Table of Contents
Advertisement
Figure 76. Set the Anti-Tilt wires to the locked position and tightening the captive screws
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
Liquid cooling cold plate with leak sensor
This is a service technician replaceable part only.
Removing a liquid cooling cold plate with leak sensor
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Using a Phillips 1 screwdriver, remove the screws that secure the rubber tube cover.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
103
Advertisement
Table of Contents
