Installing An Ocp Card - Dell PowerEdge C6620 Installation And Service Manual

Figure 91. Removing an OCP card
3. Press down the OCP card retention latch to lock it.
Next steps
1. Install the OCP filler.
2. Install the rubber tube cover. See
3. Install the expansion card riser

Installing an OCP card

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the expansion card riser
4. Remove the rubber tube cover. See
cover.
5. Remove the OCP filler.
Steps
1. Align and insert the OCP card into the sled. Slide the OCP card and push firmly until it is fully connected to the system board
connector.
NOTE: Ensure to lift the OCP card retention latch if it is in the lock position.
2. Close the OCP card retention latch to secure the card in place.
install the liquid cooling cold plate with leak sensor
1.
Safety instructions.
Before working inside your
1.
remove the liquid cooling cold plate with leak sensor
system.
Installing and removing system components
step 6 to install the rubber tube cover.
step 1 to remove the rubber tube
115