Table of Contents
Advertisement
Installing the system board
Prerequisites
NOTE:
Before replacing the system board, replace the old iDRAC MAC address label in the Information tag with the iDRAC
MAC address label of the replacement system board
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. If you are replacing the system board, remove all the components that are listed in the
CAUTION:
To avoid damage to the system board, ensure that the system board does not touch the side walls of
the sled chassis, while sliding the system board into the sled.
Steps
1. Unpack the new system board assembly.
CAUTION:
Do not lift the system board by holding a memory module, processor, or other components.
CAUTION:
Take care not to damage the system identification button while placing the system board into the
chassis.
2. Holding the system board by the edges, lower the system board into the chassis.
3. Incline the system board at an angle and align the connectors on the system board with the slots on the rear of the chassis
until the connectors are firmly seated in the slots.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 98. Installing the system board
4. Using a 5 mm hex nut driver, secure the standoff screws that secure the system board to the chassis.
5. Using a Phillips 2 screwdriver, tighten the screws that secure the system board to the chassis.
Safety
instructions.
Before working inside your system
.
removing the system board
Installing and removing system components
section.
121
Advertisement
Table of Contents
