Initiate self-test command
Request output message
command
2505 INSTALLATION MANUAL, Revision A
This message will request a complete self-test of the GPS
receiver. Results of the self-test will be automatically output
(output message 902) on the primary output port at completion
of the self-test sequence.
HEADER
$PCMG, 003*hh,CR><LF>
Example:
$PMCAG,003*47<CR><LF>
HEADER
$PMCAG,004,ccc*hh<CR><LF>
1.
Valid sentence identifiers are those listed in
the next section (except message ID 901
and 902).
Example:
Request the approved sentence GPGGA.
$PMCAG,004,GGA*2D<CR><LF>
Appendix C NMEA output protocol
CONTENTS OF DATA FIELDS
CONTENTS OF DATA FIELDS
1
sentence identifier
Page 29