Installing The 2505 - NorthStar 2505 Installation Manual

Installing the
2505
Choosing the 2505's
mounting location
Mounting the 2505
2505 INSTALLATION MANUAL, Revision A
SECTION TWO Installing and interfacing the 2505
Although the 2505 is very straightforward and easy to
understand, you must meet several basic requirements to
ensure safe and proper operation.
CAUTION!
Do not open the 2505. There are no serviceable
parts
automatically void the warranty.
The 2505 is housed in a rugged aluminum enclosure with a
mounting flange, gaskets, and watertight connectors. The 2505
itself is water-resistant, but not waterproof, so mount it where
water won't contact it directly or enter it by following power or
antenna cables. Use drip loops on all cables! Tie-wrap all cables
to keep them secure, and if cables are shortened, lengthened,
or re-terminated, seal all wiring splices.
You can mount the 2505 horizontally or vertically, using the
appropriate mounting holes; see Figure 1 on page 14. Keyhole
slots at the rear will help if you're installing the 2505 where
access is limited and it may be difficult to start the mounting
screws at the obstructed end. Securely tighten all mounting
screws to avoid vibration-related problems.
inside. Unauthorized tampering will
Page 13