Network Address - Bay Networks Remote Annex Quick Start Manual

Remote Annex Quick Start for Windows

Network Address

Remote Annex 2000
Remote Annex 4000
Remote Annex 5390
Remote Annex 5391
Remote Annex 6100
166-024-858
6
After the Remote Annex runs a series of hardware diagnostics, the
terminal displays the monitor prompt. Enter address information (step 1)
and, if you purchased a LAT key, the LAT key value (step 2).
Step 1 procedures are slightly different for the Remote Annex 6300.
For illustration purposes, sample response values indicate a Remote
Annex on an Ethernet network with the IP address 192.9.200.62. The
host system address is 192.9.200.55.
1. Enter addr and answer the prompts as shown in the
example. To accept the default shown in brackets, press the
key.
Return
monitor:: addr
Enter Internet address [<invalid or uninitialized>]::
192.9.200.62
Enter Subnet mask [255.255.255.0]::
Enter preferred load host Internet address [<any
host>]:: 192.9.200.55
Preferred load host address: 192.9.200.55
Enter Broadcast address [0.0.0.0]::
Preferred dump address [0.0.0.0]::
Select type of IP packet encapsulation (ieee802/
ethernet) [<ethernet>]::
Type of IP packet encapsulation: <ethernet>
monitor::
Load Broadcast y/n [y]::
Rev. A