Table of Contents
Advertisement
Page 126 of 160
Stored Number Redial
Redialing a Stored Number
P0891256 Standard 2.00 February 1999
Meridian 1 Attendant PC features
4 Dial the number to be stored. Click on * after every trunk access code
to ensure a pause for dial tone.
5 Click on Speed Call again. The Speed Call indicator goes off; the
access code and phone number you dialed are stored together for
speed-calling.
Note 1: To cancel a number stored against a code, click Speed
Call, enter the code, and click on *.
Note 2: Regarding Speed Call access codes:
• A one-digit access code (0 through 9) allows a Speed Call list
of up to 10 numbers
• A two-digit access code (00 through 99) allows a Speed Call
slit of up to 100 numbers
• A three-digit access code (000 through 999) allows a Speed
Call list of up too 1000 numbers.
Note 3: The phone numbers assigned to Speed Call access
codes can be 4, 8, 12, 16, 20, 28, 94 31 digits long (including any
asterisks inserted for dial-tone pauses
Stored Number Redial can be used when you hear either dial tone
or special dial tone. This means that Stored Number Redial can be
used during established calls to transfer or conference in a call.
1 Click on an idle loop key. The loop indicator goes on.
2 Click on Stored Number Redial to redial the stored number. The stored
digits are automatically dialed.
3 Dial further digits now, if needed.
Advertisement
Table of Contents
