Upgrading Code Using .Pkg - Nortel 3050 Troubleshooting Manual

•
•
When performing a reinstallation of the NVG software, access to the VPN
Gateways must be accomplished through the console port.
Procedure steps
Step
1
2
3
4

Upgrading code using .pkg

The Nortel VPN Gateway (NVG) software image is the executable code
running on the VPN Gateway. A version of the image ships with the VPN
Gateway, and comes pre-installed on the device. As new versions of the
image are released, you can upgrade the software running on your VPN
Gateway.
Copyright © 2007 Nortel Networks
.
The name of the install image.
Log in as user: boot, password: ForgetMe
Action
Log in as the boot user and provide the correct password.
Confirm the network port setting, and the IP network settings.
If the VPN Gateway has not been configured for network access
previously, or if you have deleted the VPN Gateway from the
cluster by using the /boot/delete command, you must provide
information about network settings such as interface port, IP
address, network mask, and gateway IP address. No suggested
values related to a previous configuration will be presented within
square brackets.
Select a download method, specify the server IP address, and
the boot image file name.
If the FTP server does not support anonymous login, enter the
required FTP user name and password. Anonymous login is the
default option.
Log in to the VPN Gateway as the admin user, after the device
has rebooted on the newly installed boot image.
After the new boot image has been installed, the VPN Gateway
will reboot and you can log in again when the login prompt
appears. This time, log in as the admin user to enter the Setup
menu.
Nortel VPN Gateway
Troubleshooting Guide
NN46120-700 01.01 Standard
12 October 2007
Upgrading code using .pkg 21
--End--