Summary of Contents for BEMIS bioBidet Discovery DLS
Page 1
Tools This is a guide for replacing the seat for the Discovery DLS. Follow along to the instructions depending on which part you have that needs replacing instructions. Bio Bidet By Bemis is not Phillips screw driver responsible for any damages that result from attempting this repair/replacement at home. If...
Page 2
Discovery DLS Seat Replacement Remove Dampers • To replace the seat/lid, you will need to remove the seat and lid dampers first. • Use a phillips screwdriver to take out the first damper. Set the screws aside. • Remove the second damper using the same screwdriver. Set the screws aside. Unclip Wires •...
Page 3
Discovery DLS Seat Replacement Replace Seat • Place the new replacement seat upside down down. • Line up the lid to the housing and lay it upside down shown in the second picture. It should be loosely connected. • Carefully thread the wires of the new seat through the side hole of the housing. Reattach Dampers •...
Page 4
Discovery DLS Seat Replacement Reclip Wires To Control Panel • Reconnect the clipped wires back into the control board. There are red dots on the left photo that tell you which wires need to be connected again. The following color coded wires should be connected back from left to right: Black, Black, Blue •...