Carrier 38MGRBQ18B-3 Service Manual page 83

38MGRBQ: Service Manual
4 COMPRESSOR
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
8. Disconnect the grounding wire (yellow-green) after
removing the handle and the right-rear panel.
9. Remove the PCB board.
REMOVE THE COMPRESSOR
1. Perform the steps from sections 1 and 2.
2. Remove the electrical control box cover.
3. Extract refrigerant gas.
4. Remove the sound insulation material and crankcase
heating cable.
5. Remove the compressor's terminal cover and disconnect
the crankcase electric heater wires and the compressor
from the terminal.
6. Remove the discharge pipe and suction pipe with a burner.
7. Remove the hex nuts and washers securing the compressor
to the bottom plate.
8. Lift the compressor.
83