Nortel Nautica 4000 Release Note page 31

Nauticars 4.132r release notes for the nautica 4000

Hide thumbs Also See for Nautica 4000:

Table of Contents

box# mod dev wan/wan01

device/wan/wan01# mode frame

[Save] device/wan/wan01# speed 128000

[Save] device/wan/wan01# frmgmt ansid

[Save] device/wan/wan01# pty frame

[Save] device/wan/wan01# autopvclearn all

[Save] device/wan/wan01# pop

[Save] box# save

box#

path/frr/w01-p01# ipaddr 192.168.44.2

[Save] path/frr/w01-p01# ipmask 24

[Save] path/frr/w01-p01# save

path/frr/w01-p01#

300221-C Rev.00

Firstly change your WAN device as follows:

A frame relay path is automatically created and named. It is

necessary to modify this path to add an IP address and subnet

mask. Connect the cable to your frame relay network or

switch and type the following (the path name used here is an

example only):

box# mod pa frr/w01-p01

Caution:

Only the BRI-ST and BRI-U ISDN modules can be

installed into the Nautica 4000. Older ISDN BRI modules, such

as those from a Nautica CLAM or Marlin, cannot be fitted to a

Nautica 4000 as damage to the router and the module may

occur.

Guidance Notes

2-13

Table of Contents