Command Conversions; Blacklisting - Bay Networks Nautica 200 Release Note

Command Conversions

Blacklisting

119136-D Rev. 00
If you are upgrading from NauticaRS 4.123R, the following is a
comparison of the common commands between the two versions:
Table 2-1.
NauticaRS 4.123R
sh isdn call
sh isdn hist
sh dev stat
sh dev stat isdn/isdn01
sh pa stat
sh pa stat lan01
sh pa stat isdn01
clear isdn01
cancel <pathname>
sh config
sh ip route
For a full listing of BCC commands, refer to the NauticaRS 5.0R
Reference Guide on the Nautica 200 installation CD.
Since the default blacklist timeout is now 20 seconds, users in
countries where the PTT charges for all ISDN call attempts (such
as in Austria or Switzerland) must set the blacklist timeout to 0 to
avoid the possibility of running up a large ISDN bill. For the vast
majority of users worldwide, where failed ISDN calls are not
chargeable, 20 seconds is a very reasonable timeout.
4.123R to 5.016R Command Changes
NauticaRS 5.016R
sh call
sh hist
sh dev
sh dev isdn/isdn01
sh pa
sh pa lan01
sh pa <pathname>
clear call isdn01
cancel <pathname>
sh config
sh ip route
Guidance Notes
2-11