Installing The Cutting Tool - Roland TrueVIS LG-640 Setup Manual

2. Installing the Cutting Tool

Installing the Cutting Tool

Procedure
1.
Tap .
2.
Tap [Maintenance]>[Blade Replacement].
3.
Tap [Execute].
The cutting carriage moves to a position where the blade can be installed.
4.
When the message [Open the front cover.] appears on the screen, open the front cover.
5.
Loosen the cutting carriage screw in the order shown in the figure.
6.
Install the cutting tool in the cutting carriage.
7.
Tighten the screw.
48
Installation