Stutter Dial Tone - Nortel Remote Office 9110 Release Note

December 2003
Remote Office 911x series unit needs a re-boot after unplugging/
re- plugging telephone cord
You must re-boot a Remote Office 911x series unit after unplugging and
re-plugging its telephone cord.
Remote Office 911x series unit sometimes drops dialtone
If a user attempts a call during registration, the Remote Office 911x series unit
can drop dialtone as the digital telephone set is synchronized between the
Remote Office 911x series unit and the RLC. Wait 7-10 seconds for the system
to synchronize.
Send button versus OK button on Configuration Manager
The changes to the remote connections from all Configuration Manager property
sheets and dialog boxes are not saved when you press the OK button. However,
when you press the SEND button, only the information pertaining to the current
remote unit is sent to the RLC. Refer to the Installation and Configuration
manual for your specific Remote Office unit for further details.

Stutter dial tone

A stutter may be heard during a remote dial tone. This is a normal occurrence
and is caused by the DSP activating a dial tone relay. To eliminate stutter dial
tone, disable Dialtone Relay in the Advanced Configuration dialog box, which is
available on the RLC System Configuration Property sheet in Configuration
Manager. Refer to "Advanced Configuration for upgrades" on page 19 and
"Advanced Configuration settings" on page 65 for details.
Transferring calls from the analog port not possible
You cannot transfer a call on the analog port of a telephone set connected to a
Remote Office unit. Remote Office does not support Switch Hook flash.
1.4.2 Release Notes for Remote Office and RLC 49