Table of Contents
Advertisement
Ratchet for jack
R
Pr Prepar
eparing t
ing the v
he vehicle f
ehicle for a wheel c
or a wheel change
R R eq equir uirements:
ements:
The vehicle is not on a slope.
R
The vehicle is on solid, non-slippery and level
R
ground.
The required tyre-change tool kit is available.
R
%
If your vehicle is not equipped with the tyre-
change tool kit, consult a quali ed specialist
workshop to nd out about suitable tools.
Apply the electric parking brake manually.
#
Move the front wheels to the straight-ahead
#
position.
Shi the transmission to position j.
#
Switch o the vehicle.
#
Make sure that the vehicle cannot be started.
#
Place chocks or other suitable items under the
#
front and rear of the wheel that is diagonally
opposite the wheel you wish to change.
If necessary, remove the wheel trim/hub
#
caps .
Raise the vehicle (
hange
#
F F itting/r
itting/remo
emoving t
R R emo
emoving
ving
Remove socket
#
the vehicle tool kit.
Position socket
#
Position wheel spanner
#
Using wheel spanner 3, turn hub cap
#
anti-clockwise and remove it.
page 353).
/
ving the hub cap
he hub cap
2
and wheel wrench
3
2
on hub cap 1.
3
on socket 2.
1
F F itting
itting
Before tting, check hub cap
#
wheel area for dirt, and clean if necessary.
Position hub cap
1
#
right position.
Position socket
2
on hub cap 1.
#
Position wheel wrench
#
tighten hub cap 1.
%
Speci ed
Speci ed tight
tightening t
ening torq
R R aising t
aising the v
he vehicle when c
ehicle when changing a wheel
R R eq equir uirements:
ements:
There are no persons in the vehicle.
R
The vehicle has been prepared for a wheel
R
change (
page 353).
/
from
Important notes on using the jack:
Use only a vehicle-speci c jack that has been
R
approved by Mercedes-Benz to raise the vehi-
cle.
The jack is only designed for raising and hold-
R
ing the vehicle for a short time while a wheel
Wheels and tyres 353
353
1
and the
and turn until it is in the
3
on socket
2
and
orque:
ue: 25 Nm.
hanging a wheel
Advertisement
Table of Contents
