Table of Contents
Advertisement
%
If you switch the power supply o and on
again within 20 minutes, the previous seat
ventilation setting for the driver's seat will
remain active.
Switc
Switching AIRSC
hing AIRSCARF
ARF on/o
on/o
& W W ARNING
ARNING Risk of burns caused by the
heating output from AIRSCARF being too
high
When AIRSCARF is switched on, very hot air
can ow from the outlet opening in the head
restraints.
Turn the heating output down in good
#
time.
Maintain a suitable distance from the
#
outlet opening.
R R eq equir uirements:
ements:
The power supply is switched on.
R
AIRSCARF uses heated air to warm the head and
neck area of vehicle occupants. The warm air
ows out of the vents in the head restraints.
Press button
1
repeatedly until the desired
#
heating level is set.
Depending on the heating level, up to three
indicator lamps will light up. If all the indicator
lamps are o , AIRSCARF is switched o .
Seats and stowing 117
%
When switching on, the blower will start up
only a er a preheating phase lasting a few
seconds.
A er switching o , the blower will continue to
run for a few seconds to cool down the heat-
ing elements.
%
If the vehicle battery voltage is too low, AIR-
SCARF may switch o .
Adjust the AIRSCARF vent (
#
Make sure that no objects are covering the air
inlet grille on the back of the head restraints.
117
page 156).
/
Advertisement
Table of Contents
