Table of Contents
Advertisement
332 Breakdown assistance
332
Let the tyre in ation compressor run for a
#
maximum of ten minutes.
The tyre should then have attained a tyre pres-
sure of at least 200 kPa (2.0 bar/29 psi).
If tyre sealant leaks out, make sure you clean the
a ected area as quickly as possible. It is prefera-
ble to use clean water.
If you get tyre sealant on your clothing, have it
cleaned as soon as possible with perchloroethy-
lene.
If, If, a er
a er t t en minut
en minutes, a tyr
es, a tyre pr
e pressur
essure of 200 kPa
(2.0 bar/29 psi) has no
(2.0 bar/29 psi) has not been att
t been attained:
Switch o the tyre in ation compressor.
#
Unscrew the lling hose from the valve of the
#
defective tyre.
Please note that tyre sealant may leak out when
unscrewing the lling hose.
Drive forwards or in reverse very slowly for
#
approximately 10 m.
Pump up the tyre again.
#
A er a maximum of ten minutes the tyre pres-
sure must be at least 200 kPa (2.0 bar/
29 psi).
& W W ARNING
ARNING Risk of accident due to the
speci ed tyre pressure not being attained
If the speci ed tyre pressure is not attained
a er the speci ed time, the tyre is too badly
damaged. The tyre sealant cannot repair the
tyre in this instance.
e of 200 kPa
The braking and driving characteristics may be
ained:
greatly impaired.
Do not continue driving.
#
Consult a quali ed specialist workshop.
#
If, If, a er
a er t t en minut
en minutes, a tyr
(2.0 bar/29 psi) has been att
(2.0 bar/29 psi) has been attained:
Switch o the tyre in ation compressor.
#
Unscrew the lling hose from the valve of the
#
defective tyre.
es, a tyre pr
e pressur
essure of 200 kPa
e of 200 kPa
ained:
& W W ARNING
ARNING Risk of accident from driving
with sealed tyres
A tyre temporarily sealed with tyre sealant
impairs the handling characteristics and is not
suitable for higher speeds.
Adapt your driving style accordingly and
#
drive carefully.
Do not exceed the maximum speed limit
#
with a tyre that has been repaired using
tyre sealant.
Observe the maximum permissible speed for a
#
tyre sealed with tyre sealant 80 km/h.
* N N O O TE TE Staining from leaking tyre sealant
A er use, excess tyre sealant may leak out
from the lling hose.
Therefore, place the lling hose in the
#
plastic bag that contained the TIREFIT
kit.
Advertisement
Table of Contents
