Job Aid: Connector Cleaning Tools And Materials; Cleaning Single Sc And Fc Connectors - Nortel 8300 Installation Manual

14 Safety and regulatory information

Job aid: connector cleaning tools and materials

You need the following tools and materials to clean fiber optic connectors.
•
•
•
•

Cleaning single SC and FC connectors

Clean connectors so that the optical signal is minimally attenuated by the
connector.
Procedure steps
Step
1
2
3
4
Copyright © 2007, Nortel Networks
.
Lint-free, nonabrasive wiping cloths
Cotton swabs, with a tightly wrapped and talcum-free tip
Optical-grade isopropyl alcohol (IPA)
Canned compressed air with extension tube
CAUTION
To avoid contamination, optical ports should only be cleaned when
there is evidence of contamination or reduced performance, or
during their initial installation.
To prevent oil contamination of connectors, do not use commercial
compressed air or house compressed air in place of canned
compressed air.
Do not allow the air extension tube to touch the bottom of the
optical port.
Action
Remove dust or debris by applying canned air to the cylindrical and
end-face surfaces of the connector.
Gently wipe the cylindrical and end-face surfaces with a pad or a
wipe dampened with optical-grade isopropyl alcohol.
Gently wipe the cylindrical and end-face surfaces with a dry, lint-free
tissue.
Dry the connector surfaces by applying canned air or letting them
air dry.
To prevent contamination, do not touch the connector surfaces after
cleaning; and cover them with dust caps if you are not going to use
them right away.
Nortel Ethernet Routing Switch 8300
Installation — SFPs and XFPs
NN46200-307 01.02 Standard
4.0 27 August 2007
—End—