Bay Networks 5399 Quick Start Manual page 23

Set the Operating Image
The default operating image is shipped with the RAC and is stored in
flash memory. Verify or set the operating image as follows:
1. At the ROM monitor prompt, enter image and respond to the
prompts as shown in the example. To accept the default shown
in brackets, press the Return key.
monitor:: image
Enter Image name [(ip) "oper.64.enet", (mop)
"OPER_64_ENET.SYS"]::
Enter TFTP Load Directory[""]::
Enter TFTP Dump path/filename:: 192.9.200.62
2. After you enter the image name, enter im -d to verify the
operating image.
3. After you verify the operating image, set the interface sequence.
Configure the Interface Sequence
The interface sequence determines the order or method in which the RAC
boots. You can configure the RAC for network, self-boot, or both. To set
the sequence:
1. At the ROM monitor prompt, enter seq. The system responds:
Enter a list of 1 to 4 interfaces to attempt to use
for downloading code or upline dumping. Enter them in
the order they should be tried, separated by commas
or spaces. Possible interfaces are:
Ethernet: net
SELF: self
Enter interface sequence [net]::
If the RAC is configured for self-boot, copy the configuration
(config.annex) file from the server to the RAC using FTP. Do this after
you boot the RAC.
2. After you enter the sequence, enter seq -d to verify the interface
sequence.
Quick-Start Guide for Remote Access Concentrators
118352-A Rev. A
7